Still awaiting parts from Elegoo to fix all three units. Contacted Elegoo when the unit started making noise like it was out of balance, they were quick to respond and siad they would send the required parts to fix all three units. It has been 2 weeks and when I did some research it appears that getting the parts from the manufacturer takes approx. 4 - 5 weeks.Recommended addition to the Elegoo Mercury. Nice to have a second wash container, I use one for pre wash and the second for final wash allowing for less consumption of my IPA.Shame on me for not paying better attention to the item description. This bucket is not the same size as the original; it is in fact about 25 mm shorter. While not a showstopper for me it is definitely my fault for not reading the description better.Having said that this item is made with the same quality as the original.I ordered this because I needed another bucket for my wash station that is v2.0 (with a larger bucket that is not on sale).I expected this to be somewhat smaller and it is. The wire rack from v2.0 does not fit, but I believe I can still was parts without the lid on.The magnet aligns well and it works as expected.I hope the v2.0 bucket shows up soon.Having extra buckets to hold the rinsing fluids is great. I use 3, one for white prints, one for black prints and one for a second rinse. I find them well engineered and easy to clean. As often happens after rinsing a print the resin rinsed off in the bucket settles to to the bottom where it ends up as a sticky mess that gums of the propeller. It's a simple matter of poring out the fluids into another container, cleaning up the gunk at the bottom, removing the screw holding the propeller in place and completing the clear up. I love it.Purchased this in the hopes of having a second bin to use for washing 3D prints. It has no basket which would prevent prints form hitting the propeller and having to plave my hand, gloved or not, into the bin to retrieve the now clean print.The only other issue is that it will not work with the Elegoo Mercury X Bundle wash base.I have multiple wash buckets incorporated into my workflow. It is a design that just makes sense.Absolutely AIR TIGHT! Long lasting material. Easy to clean. Tough and durable. So why did I need a replacement? I didn't. I wanted a second one so I could start a clean a new print while this was in use. Cheaper than buying a second washer to support a second printer!